The High Energy X-ray telescope (HE) onboard the Insight-HXMT astronomy satellite

The Insight-Hard X-ray Modulation Telescope(Insight-HXMT) is a broadband X-ray and γ-ray(1-3000 ke V) astronomy satellite. One of its three main telescopes is the High Energy X-ray telescope(HE). The main detector plane of HE comprises 18 Na I(Tl)/Cs I(Na) phoswich detectors, where Na I(Tl) is used as the primary detector to measure ~ 20-250 ke V photons incident from the field of view(FOV) defined by collimators, and Cs I(Na) is used as the active shielding detector to Na I(Tl) by pulse shape discrimination. Additionally, Cs I(Na) is used as an omnidirectional γ-ray monitor. The HE collimators have a diverse FOV,i.e. 1.1°×5.7°(15 units), 5.7°×5.7°(2 units), and blocked(1 unit). Therefore, the combined FOV of HE is approximately5.7°×5.7°. Each HE detector has a diameter of 190 mm resulting in a total geometrical area of approximately 5100 cm2, and the energy resolution is ~15% at 60 ke V. For each recorded X-ray event by HE, the timing accuracy is less than 10 μs and the deadtime is less than 10 μs. HE is used for observing spectra and temporal variability of X-ray sources in the 20-250 ke V band either by pointing observations for known sources or scanning observations to unveil new sources. Additionally, HE is used for monitoring the γ-ray burst in 0.2-3 Me V band. This paper not only presents the design and performance of HE instruments but also reports results of the on-ground calibration experiments.     

Positive ground state solutions for Schrödinger–Poisson system with critical nonlocal term in ℝ3

This paper is dedicated to studying the following Schrödinger–Poisson system $$\left\{\begin{array}{ll}-\mathrm{\Delta }u+V(x)u-K(x)\varphi |u{|}^{3}u=a(x)f(u),& x\in {ℝ}^3,\\ -\mathrm{\Delta }\varphi =K(x)|u{|}^5,& x\in {ℝ}^3.\end{array}\right.$$ Under some different assumptions on functions V(x), K(x), a(x) and f(u), by using the variational approach, we establish the existence of positive ground state solutions.     

Ni(111)表面一氧化碳和氢共吸附的密度泛函理论研究

本文用密度泛函理论(DFT)的总能计算研究了一氧化碳和氢原子在Ni(111)表面上p(2×2)共吸附系统的原子结构和电子态，结果表明CO和H原子分别被吸附于两个对角p(1×1)元胞的hcp和fcc位置.以氢分子和CO分子作为能量参考点，总吸附能为2.81 eV，相应的共吸附表面功函数φ为6.28 eV.计算得到的C—O，C—Ni和H—Ni的键长分别是1.19?, 1.96?和 1.71?，并且CO分子以C原子处于hcp的谷位与金属衬底原子结合.衬底Ni(111)的最外两层的晶面间距在吸附后的相对变化分别是 关键词： Fisher-Tropsch反应 催化作用 Ni(111) p(2×2)/(CO+H) 共吸附     

二维变系数反应扩散方程的紧交替方向差分格式

1 引言 在研究热传导过程、气体扩散现象和电磁场的传播等问题时，常常遇到抛物型偏微分方程。用有限差分方法研究这类问题的数值解法目前已经有了许多工作。对于二维、三维抛物方程的数值求解比较理想的方法是交替方向法。     

Anti-BZ-Structure in Effect Algebras

The definitions of sharply approximating effect algebras, anti-BZ-effect algebras, central approximating effect algebras, and S-anti-BZ-effect algebras are given, the relationships between sharply approximating effect algebras and anti-BZ-effect algebras, between central approximating effect algebras and anti-BZ-effect algebras are established, and the set of anti-BZ-sharp elements in S-anti-BZ-effect algebras is proved to be an orthomodular lattice.     

Synthesis,characterization, and curing kinetics of novel ladder‐like polysilsesquioxanes containing side‐chain maleimide groups

Two ladder‐like polysilsesquioxanes (LPS) containing side‐chain maleimide groups have been synthesized successfully by reacting N‐(4‐hydroxyphenyl)maleimide (HPM) with LPS containing 100 mol % of chloropropyl groups (Ladder A ) and 50 mol % of each methyl and chloropropyl group (Ladder B ). HPM was synthesized by reacting maleic anhydride with 4‐aminophenol, and the resulting amic acid was imidized using p‐toluenesulfonic acid as a catalyst (Scheme 1 ). The LPSs were characterized by Fourier transform infrared (FTIR), ¹H nuclear magnetic resonance (NMR), proton‐decoupled ¹³C NMR, ²⁹Si NMR, wide‐angle X‐ray diffraction (WAXD), differential scanning calorimetry (DSC), and thermogravimetric analysis (TGA). Characterization indicated that these polymers had ordered ladder‐like structures with possible defects. These polymers were soluble in common solvents at ambient temperature, which suggested that they were not crosslinked. Both the polymers and the HPM were cured, and their kinetics were followed by dynamic DSC. The Ozawa and Kissinger methods were used to calculate activation energies for curing. Curing increased the temperature at which both 5% weight loss and maximum rate of weight loss were observed. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 4036–4046, 2004     

三种群食物链交错扩散模型的整体

本文应用能量估计方法和Gagliardo-Nirenberg型不等式证明了一类强耦合反应扩散系统整体解的存在性和一致有界性，该系统是带自扩散和交错扩散项的三种群Lotka-Volterra食物链模型．通过构造Lyapunov函数给出了该模型正平衡点全局渐近稳定的充分条件．     

二维正方各向异性碲圆柱光子晶体完全禁带中缺陷模的FDTD计算分析和设计

用FDTD方法计算了二维正方晶胞各向异性碲圆柱光子晶体的点缺陷模.为了得到TE,TM模式在完全禁带中具有相同共振频率的缺陷模,对中心点缺陷半径Rd以及中心附近对称位置的点缺陷半径Rn做了一系列微调.计算表明,TM模对于Rn的变化不敏感,而TE模随着Rn的改变出现了明显的规则的移动趋势.通过计算分析,发现对应于f=0.4的背景(R=0.3568a),当Rd=0.55a,Rn=0.26a时在完全禁带中TE和TM的缺陷模具有相同的共振频率ω0=0.2466ωe(其中ωe=2πca,a为晶格常数) 关键词： 时域有限差分法 光子晶体 缺陷模 各向异性     

Surface profile measurement of low-frequency vibrating objects using temporal analysis of fringe pattern

A simple and accurate algorithm (phase scanning method) is proposed for 3D surface contouring and dynamic response determination of a vibrating object. A sinusoidal fringe pattern is projected onto a low-frequency vibrating object by a programmable liquid crystal display projector. The fringe patterns are captured by a high-speed CCD camera with a telecentric gauging lens. Phase values are evaluated point by point using phase scanning method. From the phase values of each point on the object, the contour of the specimen at different instants of vibration can be retrieved. In this paper, a small vibrating coin is used to demonstrate the validity of the method and the experimental results are compared with test results on a stationary coin using four-step phase shifting and fast Fourier transform methods. The technique is especially useful in applications where the vibrating object has a complicated shape.     

非化学配比锰基钙钛矿输运特性研究

本文报道了用溶胶凝胶法并经过低温(900℃)后处理制备的具有非化学配比的La2/3Ca1/3Mn1-xO3(x=0～0.10)多晶样品的电输运和磁性质的实验研究.结果表明,随x的增加,样品呈现出明显增强的非本征磁电阻效应,同时其本征磁电阻效应减弱.实验还观察到样品的颗粒尺寸随x的增加而减小的现象.基于样品的结构特征,本文讨论了其独特输运性能的形成原因.